Hello you lot, its me again Jeff

Well what can I say Ive been a bit bizzy doing all sorts of stuff all over the place ,

Ive got a couple of engines to do a petrol / tvo conversion motor in bits that Ive got to rebuild and convert back to petrol just a straight forward job. just a carb and ignition set up after the build

the second a diesel that's now got a new block as its old one was a right state with a full spider wed thanks to some one centre doting the core plugs in , any way here's some pictures of what Ive been up to , along with a few lines

first a nice little alternator conversion I also rewired the tractor and  did the half shaft bearings and seal ,relined the brakes and  recentered them in the brake drums  then set and balanced them , then set the carb up ,

 anyway then i went out to look at a couple of old Ferguson greys and came across this lot and these are only some of the old tractors

with a nice mid mounted mower

a big old major with a hell of a crane for a tractor

and this

and this

and hiding under a sheet this

then I started to build charlies engine

after sorting out this lot, and putting in new base seals and liners

pistons , rings , pins ,

big ends , mains , thrust plates and stuff and things

and oil pump rotor and shaft

and governor weights and plate and chain

I will add the rest of what Ive been upto tomorrow